Page 2 of 2
- <
- >
-
- Dangerdave
- Member Since: 15 Feb 2017
- Location: UK
- Posts: 600
-
- Labergorce
- Member Since: 13 Sep 2018
- Location: Bath
- Posts: 4
-
-
- Arslanoff
- Member Since: 03 Aug 2017
- Location: Prague
- Posts: 140
Labergorce wrote:
Does anyone know if the LR half height dog guard or the travail or guardsman ones allow the third row of seats to be deployed while it's in situ?
cheers
With LR half height dog guard, you can not deploy the third row (first you have a sign that you are not allowed to and the second the connection points on the legs of the guard are bright enough to cover a part of the third-row seats angles and it stops the seats from opening. But you still can disconnect the guard, open the seats and connect it back if you want
Land Rover Discovery 5 HSE Luxury Td6 in Carpathian Grey -
- Whippetman
- Member Since: 16 Feb 2019
- Location: North Somerset
- Posts: 395
IndusD4 wrote:
I have the "Loadspace partition full height - VPLRS0374" fitted but it rattles at the top. The purple sections are spring loaded into the frame and are loose:
Anyone got any ideas of how to stop the rattle? It would pretty much be a permanent fixture in the car but it might be good to be able to take it out still. We have 2 Retrievers and a Weimaraner pup joining the pack early September.
Thanks
Ron
This retails at £340 in uk and rattles.
I had it and eventually got a full refund for mine.
The Trevall half guard at around £130 is much better and easier to fit/ remove without rattles
HSE LUX, Aintree Green GONE -
- Jambo
- Member Since: 16 Sep 2017
- Location: Cumbria
- Posts: 21
-
I have the LR one which initially rattled at the top as others have mentioned (although only on one side). Quick fix for me was to wrap black insulating tape around the top connector - two or three layers and now the connector is a snug fit, so it doesn't rattle and the tape isn't noticable
Works a treat and I leave the guard in place permanently, unless I need to use third row seats. -
- Whippetman
- Member Since: 16 Feb 2019
- Location: North Somerset
- Posts: 395
-
-
- Road Runner 2017
- Member Since: 14 Jan 2017
- Location: Scotland
- Posts: 2010
Try using plastic flexible tubing. The type you get on air horns. Just cut it to size and split down the middle and wrap it around the purple part.
I did something similar on the trailers cage, on both the rear door latches. Was driving me mad all that rattling, so the tubing did the trick and wont wear out like the tape does. Nice and tight now. Comes in various diameters and thicknesses
MY17 First Edition - 3L Diesel Td6 - Farallon Black - Roof rails,side steps,tints,tow bar,mudflaps,door strips.
MY18 Hse Luxury - 3L Petrol Si6 Supercharged - Santorini Black - Roof rails,side steps,tints,tow bar,mudflaps,door strips,22's,dynamic pack 1,bonnet vents,t.v,dual view,frontcooler,360°camera,rear cooler/warmer,roof vane,black LR badges,wade sensing,door sill plates,boot liner, solar screen,wind deflectors,service plan,tracker,speed camera detector,dual dash cameras,ceramic coating. -
- Whippetman
- Member Since: 16 Feb 2019
- Location: North Somerset
- Posts: 395
-
I guess it’s a first world problem
HSE LUX, Aintree Green GONE
Page 2 of 2
- <
- >
DISCO5.CO.UK is independent and not affiliated to Jaguar Land Rover.